E-6
CD OPERATION
NOTE: This unit not only plays commercial compact discs but also self-complied CD-RW discs.
Because of non-standardized format definition/production of CD-R/RW, playback quality &
performance is not guaranteed.
Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions such as
PC performance, writing software, media properties etc.
Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a malfunction.
PLAY MODE
1.
Slide the FUNCTION SWITCH to the “CD” position.
2.
Open the CD DOOR, load a CD with the label side facing upward and then close the CD door.
3.
Disc information (total number of tracks) will appear on the LED DISPLAY.
4. Press PLAY/PAUSE BUTTON to start playing the CD, the PROGRAM/PLAY INDICATOR will light
steadily.
5. While playing, press the PLAY/PAUSE BUTTON to pause, the TRACK No.
will flash. Press
PLAY/PAUSE BUTTON again to resume playing.
6.
Adjust the VOLUME CONTROL to the desired volume level.
7.
Press STOP BUTTON to stop playing.
8.
To turn off the CD player, slide the FUNCTION SWITCH to “OFF”.
NOTE:
If skipping occurs during CD play, try turning the volume down.
Do not open the CD DOOR when a CD is playing.
REPEAT MODE
Repeat 1
When the REPEAT BUTTON is pressed once, the REPEAT INDICATOR will light and blink continuously.
The current track will be repeated until it is interrupted.
Repeat All
When the REPEAT BUTTON is pressed twice, the REPEAT INDICATOR will light steadily. The whole disc
will be played continuously.
To Cancel Repeat Function:
Press the REPEAT BUTTON until the repeat indicator is off.
SKIP AND SEARCH MODE
1.
During Play or Pause mode, tap the SKIP FORWARD "
" or SKIP BACKWARD "
" BUTTON to go to
the next track or go back to the beginning of the current track.
2. During play mode or Pause mode, press and hold the SEARCH FORWARD "
" or SEARCH
BACKWARD "
" BUTTON to search within the current track with audible high speed playback.
PROGRAM PLAY MODE
This function allows music tracks to be played in a programmed sequence.
NOTE: Program can only be set in STOP mode.
1.
Press the PROGRAM BUTTON once. “01” in the LED DISPLAY and PROGRAM INDICATOR both will
flash.
2.
Press the SKIP FORWARD "
" or SKIP BACKWARD "
" BUTTON to select the track to be
programmed.
3.
Press the PROGRAM BUTTON again to store the selection. The LED DISPLAY will advance to “02” and
flash to prompt for the next input.
4.
You may repeat steps #2 to #3
to program up to 20 tracks. As soon as you have entered the 20th track,
the LED DISPLAY will automatically show the programmed tracks one by one in their correct sequence
starting from the first. At the end of program review, “01” in the LED DISPLAY and PROGRAM
INDICATOR will both flash.
5.
Press PLAY BUTTON to complete and start program play. The PROGRAM/PLAY INDICATOR will blink.
Press STOP BUTTON to stop.
6.
Normally all the programmed tracks will be played through once and then stop. However, you may use
the REPEAT function to repeatedly play a certain track (Repeat 1) or all tracks in the program (Repeat
