PREPARATION FOR USE
Unpacking and Setup
* Carefully remove the unit from the display carton and remove all packing material from the unit itself.
* Remove any descriptive labels that may be found on either the front or top cabinet of the unit. Do not
remove any labels located on either the back or button cabinet of the unit.
POWER SURRLY
Using AC Power
1.
Check if the power voltage, as shown on the type plate located on the bottom of the set,
corresponds to your local AC power supply. If it does not, consult your dealer or service
center.
2.
Connect the power cord to the AC socket inlet and the wall outlet. the power supply is now
connected and ready for use.
3.
To switch off completely, unplug the power cord from the wall outlet.
4.
Unplug the power cord from the wall outlet to protect your set during heavy thunderstorms.
Using DC Power—inserting Batteries (not included)
1. Open the battery compartment. This unit takes 4 x D size batteries.
2. Insert batteries into the battery compartment, making sure that the batteries are installed in the
designated numerical order and that the Proper Polarities (+ and -) are maintained, to Prevent
possible damage to the unit:
(preferably Alkaline) with the correct polarity as indicated by the + and - symbols
inside the compartment
Batteries contain chemical substances, so they should be disposed of properly.
*Incorrect use of batteries can cause electronic leakage and will corrode the compartment or cause
the batteries to burst. Therefore:
*Do not mix battery types: e.g. alkaline with carbon Zinc. Only use batteries of the same type for
the set.
*When inserting new batteries, do not mix old batteries with new ones.
*Remove the batteries if the set will not be used for a long time.
BATTERY LIFE
IF THE SOUND BECAOMES LOW OR DISTORTED, REPLACE ALL THE BATTERIES
WITH NEW ONES.
