Power Station LV101
11
DIGITAL plus
decoder equipped), since their direction of travel is dependent on
track polarity.
Connecting the LV101 to Other DCC Systems
The LV101 has been designed to be used with a broad range of
NMRA DCC systems. Following are diagrams to assist you in
connecting the LV101.
Troubleshooting the LV101
Problem
Cause
Solution
LV101 is not
operational LED does
not light up)
Power supply is interrupted,
power plug of transformer is not
in outlet or "U", "V" wires are not
connected to the transformer.
Ensure that the transformer
is on, has not overloaded or
shut off, check wiring from
transformer to LV101
There is a short circuit on the
layout.
Remove the cause of the
short circuit.
LED flashes
There is a power overload.
Divide the layout into several
supply sections and power
these with additional power
stations/transformers.
The connection between LV101
and command station LZ100 is
broken , or there is a short circuit
(terminals C and D)
Check and correct these
connections.
The command station is not
transmitting packets.
Exit programming mode or
press F followed by 1
LV101 is operational
(LED lights), but
The connection from Power
Station to track is broken
(terminals J and K).
Test and correct
connections.
locomotives do not run The command station off
Press F followed by 1
