Changes to the LH100
9
1
3
8
Press 'Enter' to complete the entering
process and store the new setting in
the command station. Press 'Esc' to
return to controlling the locomotive
without storing the setting.
2.6
'Refreshing' functions
By 'refreshing' functions we mean the following: In defined regular
intervals the command station sends function information via the track
to all decoders located on the track. This ensures that a decoder does
not 'forget' all settings, even if the connection between command
station and decoder is interrupted intentionally (due to 'dead frogs') or
unintentionally (due to dirt on the track or power interruptions).
For very large layouts with very many locomotives or decoders it may
make sense to deactivate the cyclic transmission of individual
functions to decrease the time delay resulting from the total time
required for each transmission (typically 8 mS).
This way, you can decide which function information is transmitted
cyclically and which not. Ex-works, the information of functions 0 to 8
is transmitted cyclically. 'Refreshing' affects all locomotive addresses.
To 'refresh' functions, proceed as follows:
1
3
8
Start with 'controlling the locomotive'.
It does not matter which locomotive
address you select.
The menu that was selected
last is displayed.
Functions F0 to F8 are transmitted
cyclically.
Use '+' to scroll through the options:
Functions F0 to F12 are transmitted
cyclically.
