Information SET-02
15
DIGITAL plus
Example 1: entering a 2-digit digit address
In the following example the current address "03" in the stack is
changed to "46". The locomotive with the address 3 will remain
running on the layout with the LH200 knob position that was present
before the menu option was selected. In the following the user
action is on the left and the display results are on the right.
First you select the address menu:
+
0
M
Go to the menu "Enter a new
digit address into the stack"
Now confirm the address menu selection with the "A " key:
A
Now the entire right digit of the address
(the ones digit) flashes on the display.
Alter the value of this digit by turning the
rotary control-knob to the right (value
increases) or to the left (value decreases).
In this example the value is altered to 6.
3
7
Now select the 10s digit. The value 6 is
now valid as the ones digit and the 10s
digit begins to flash.
Turn the rotary control-knob until the
desired value is shown and conclude the
input with key "A " key.
A
The new selected locomotive can now be
controlled by the LH200. You can now
adjust the positioning of the rotary control-
knob and the direction switch as described
above.
Example 2: entering a 4-digit address
In this example the address 46 in the stack is replaced by the
address 1234.
First we enter the address menu:
+
0
M
Go to menu " Enter a new
locomotive address into the
stack"
Now confirm the address menu selection with the "A " key:
