16
Information SET-02
A
The furthest right digit of the address
display now flashes.
Alter the value of this digit by turning the
rotary control-knob to the right (value
increases) or to the left (value
decreases). In this example the value is
altered to 4.
3
7
Now select the next digit you desire to
alter. The value 4 is now valid as the ones
digit and the 10s begins to flash.
Turn the rotary control-knob until the
desired value is shown.
2
6
If a 4-digit number locomotive is desired,
pressing either the "1" or "2" key extends
the display 2 more digits. If the "2" key is
pressed, the third digit from the right
flashes.
Turn the rotary control-knob until the
desired value for the second digit from the
left is shown, here 2.
1
5
Pressing the "1" key causes the left hand
digit to flash indicating that this is the digit
you desire to change.
Again the value is altered, in this example
it is altered to 1. End with "A " key to
complete the final take over of the
address.
A
Now adjust the position of the rotary
control-knob and the direction switch as
described above.
Until you press the check key (the "A " key), which indicates that
your selection is complete, you can switch back and fourth between
the individual digits as often as you like by pressing keys 1 through
4 until the desired address is correctly displayed on the LH200
display.
Advice:
All 4 digits of the display do not have to be altered. If certain digits
already have the correct value, you can leave them as they are and
go to the next digit.
