30
Information SET-02
Set the direction switch so that the locomotive will
operate in the proper direction when added to the
consist. In this example #3 will operate in the same
direction as the consist.
+
0
M
Enter the LH200 menu.
0
M
3x
Scroll through the menu until
the MU is shown and confirm
the selection with "A " key.
A
The multiple traction/ multi unit address
must be between 1 and 99. At this point
enter the desired multi unit address.
Alter the value of this digit by turning the
rotary control-knob to the right (value
increases) or to the left (value
decreases). In this example the value is
being altered to 5.
3
7
Select the next digit by pressing key 3.
The value of the 10s digit is now
confirmed as 0. The 10s digit now
flashes.
Again, alter the value of this digit with the
rotary control-knob.
A
With the correct MU address in the display
confirm the selection by pressing the
"A " key. The locomotive with address 3
has now been added to the multi unit
consist with MU address 55.
A
(possibly
more than
once)
Scroll further through the
stack until you reach the next
locomotive that you want to
tie into the MU or enter the
new locomotive address. In
this example it is locomotive
#4. As before set the speed
to stop (knob turned full
counter clockwise).
