Firmware
≤
11.00 - DMS 8.0 EN - 10/2011
L
253
8400 StateLine C | Reference manual
I/O terminals
6
I/O terminals
This chapter provides information on the function, possible parameter settings, and
technical data of the input/output terminals of the controller.
In the »Engineer«, the input and output terminals are parameterised on the
Terminal
assignment
tab. To do this, go to the
Control terminals
list field and select the terminals
that you wish to parameterise:
You can find further information in the respective subchapter:
Digital terminals
(
254)
Analog terminals
(
273)
Tip!
How you can alter the preconfigured assignment of the input and output terminals
is described in the chapter entitled "
User-defined terminal assignment
".
(
282)
Note!
The input and output terminals of the drive controller have already been
functionally assigned in the default setting ("Lenze setting"). The preconfigured
assignment depends on the technology application selected in
C00005
and the
control mode selected in
C00007
:
•
TA "Actuating drive speed":
Terminal assignment of the control modes
(
302)
•
TA "Switch-off positioning":
Terminal assignment of the control modes
(
329)
Wiring diagram, assignment and electrical data of the input and output
terminals can be found in the
8400 hardware manual
in the chapter "Technical
data".
• The hardware manual has been stored in electronic form on the data carrier
supplied with the 8400 drive controller.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
