Firmware
≤
11.00 - DMS 8.0 EN - 10/2011
L
33
8400 StateLine C | Reference manual
Introduction: Parameterising the controller
General notes on parameters
2.3
General notes on parameters
All parameters for controller parameterising or monitoring are saved as so-called "codes".
The codes are numbered and indicated by the prefix "C" before the code, e.g. "C00002".
Moreover, each code has a name and specific attributes, as for example access type
(reading, writing), data type, limit values and default setting ("Lenze setting").
For the sake of clarity, some codes contain "subcodes" for saving parameters. This
Manual uses a slash "/" as a separator between code and subcode, e.g. C00118/3".
According to their functionality, the parameters are divided into three groups:
– Setting parameters: For specifying setpoints and for setting device / monitoring
functions.
– Configuration parameters: For configuring signal connections and terminal
assignments.
– Diagnostic/display parameters: For displaying device-internal process factors,
current actual values and status messages. These parameters can only be read.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
