8400 StateLine C | Reference manual
Introduction: Parameterising the controller
General notes on parameters
34
L
Firmware
≤
11.00 - DMS 8.0 EN - 10/2011
2.3.1
Changing the parameterisation with the keypad
Keypad display and control elements
The keypad is simply plugged on the
diagnostic interface X6 ("DIAG") at the front
of the standard device.
Plugging and unplugging the keypad is
possible during operation.
LCD display
Headline
In the menu level: Menu name
In the parameter level: Parameter name
Three-part display
In the menu level: List of available menus
In the parameter level: Code/subcode and setting or actual value
Device status
Controller is switched on
Pulse inhibit is active
Controller is enabled
System fault is active
Controller is inhibited
"Fault" device status is active
Quick stop is active
Device status "Trouble" active
Current limit exceeded
Device status "TroubleQSP" active
Speed controller 1 in the limitation
A warning is indicated
WXST
VYR
+HDGOLQH
7ULSOHOLQHGLVSOD\
&XUUHQWIXQFWLRQ
ULJKWIXQFWLRQNH\
&XUUHQWIXQFWLRQ
OHIWIXQFWLRQNH\
/&'GLVSOD\
'HYLFHVWDWH
,QPDQXDOFRQWUROPRGH
6WDUWPRWRU
,QPDQXDOFRQWUROPRGH
6WRSPRWRU
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
