8400 StateLine C | Reference manual
Parameter change-over
Configuring the list using the »Engineer« parameterisation dialog
510
L
Firmware
≤
11.00 - DMS 8.0 EN - 10/2011
Outputs
13.2
Configuring the list using the »Engineer« parameterisation dialog
Proceed as follows to open the dialog for parameterising the parameter change-
over:
1. »Engineer« Go to the
Project view
and select the 8400 StateLine controller.
2. Go to
Workspace
and change to the
Application parameters
tab.
3. Go to the
Overview
dialog level and click the "basic functions" button.
4. Go to the
Overview
Basic functions
dialog box and click the
Parameter change-
over
button.
Identifier
Data type
Value/meaning
bDone
BOOL
"Writing of the parameter list completed" status signal
• The output is automatically reset to FALSE if writing via
bExecute
is activated
again.
TRUE Writing of the parameter list successfully completed.
FALSE The FALSE status can have the following meanings:
1.There is no active writing of the parameter list.
2.Writing of the parameter list has not been completed yet.
3.An error has occurred (if
bFail
= TRUE).
bFail
BOOL
"Error" status
TRUE An error has occurred (group signal).
• For details see display parameter
C01083
.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
