Firmware
≤
11.00 - DMS 8.0 EN - 10/2011
L
721
8400 StateLine C | Reference manual
Working with the FB Editor
Basics
15.1.1
Basic components of a drive solution
A drive solution consists of the following basic components:
Signal inputs (for control and setpoint signals)
Signal flow of the technology application
Signal outputs (for status and actual value signals)
[15-1] Basic components of a drive solution
Regarding the 8400 device series, these three components are available for the FB
interconnection and classified as follows:
Further information on the individual modules can be obtained from the following
subchapters!
Note!
With the "StateLine" version, the interconnection shown in the application level
cannot be edited.
M
...
M
n
t
è
ç
Switch-off positioning
Actuating drive speed
Setpoint
generator
Process
controller
Motion
Control
Kernel
Device
control
Motor
control
Signal
inputs
Signal
outputs
Module type
Name
Task
Example
Function block
L_
name
General function block for free
interconnection (only HighLine)
L_Compare_1
L_PCTRL_1
System block
LS_
name
Signal interface to inverter-internal
functions
LS_DigitalInput
LS_DriveInterface
Port block
LP_
name
• Process data communication via a
fieldbus using a communication module
• Process data communication via CAN on
board
LP_CanIn1
LP_CanOut1
LP_MciIn
LP_MciOut
Application block
LA_
name
Block for a technology application
LA_NCtrl
LA_SwitchPos
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
