Malfunction
Possible cause
Possible solution
The connection of the water
drain hose is not correct.
Make sure that the connection
is correct.
The water drain hose is dam-
aged.
Make sure that the water drain
hose has no damages.
The anti-flood device is on.
Close the water tap and con-
tact the service centre.
The start of the washing pro-
gramme does not occur.
The appliance door is open.
Close the appliance door.
You did not press the start/
cancel button.
Press the start/cancel button.
The mains plug is not connec-
ted in the mains socket.
Connect the mains plug.
The fuse in the fuse box is
damaged.
Replace the fuse.
After the check, turn the programme knob
on the same washing programme before
the malfunction occurred. The programme
continues from the point of interruption.
If the malfunction occurs again, contact the
service centre.
If the different alarm codes show, contact
the service centre.
The necessary information for the service
centre is on the rating plate.
Record this information:
– Model
(MOD.) ....................................................
....
– Product number
(PNC) ..........................................
– Serial number
(S.N.) ..............................................
The washing results and drying results are not satisfactory
Problem
Possible cause
Possible solution
The dishes are not clean.
The selected washing pro-
gramme was not applicable for
the type of load and soil.
Make sure that the washing
programme is applicable for the
type of load and soil.
The baskets were not loaded
correctly, water did not touch
all surfaces.
Load the baskets correctly.
The spray arms could not turn
freely because of incorrect ar-
rangement of the load.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
The filters are dirty or not as-
sembled and installed correctly.
Make sure that the filters are
clean and correctly assembled
and installed.
The quantity of detergent was
not sufficient or missing.
Make sure that the quantity of
detergent is sufficient.
Limescale particles on the
dishes.
The salt container is empty.
Fill the salt container with dish-
washer salt.
Incorrect water softener adjust-
ment
Adjust the water softener.
The salt container cap is not
closed correctly.
Make sure that the salt contain-
er cap is closed correctly.
28
leonard
Summary of Contents for LI1310
Page 59: ...leonard 59 ...
Page 60: ...156954780 A 152011 ...
