3.1.8 LOAD indicator: The indicator displays how much power UPS is supplying
compare with its full capacity.
3.1.9 BATTERY indicator: The indicator displays how much backup power stored in
battery compare with its full capacity of battery.
3.1.10 LOW BATT. indicator: The indicator display when battery energy is almost gone.
After the indicator is on for 2 minutes, UPS will shut down to protect battery
life.
3.1.11 OVER TEMP. indicator: Indicates when temperature inside the UPS is too high
for the UPS to operate.
3.1.12 FAULT indicator: Indicates when UPS is malfunction.
3.2.13 SNMP AGENT (option): The additional port to connect the LAN cable to
computer network to monitor electrical and UPS status via SNMP/HTTP. Read
more details in Net Agent manual.
3.2.14 BATTERY TERMINAL (for NBP0811 and NBP1011) : The teminal for connecting
to extension battery unit.
3.1.13 LCD DISPLAY: The screen to displays Input voltage (Vin), Output voltage (Vout),
Battery Level (%B) and Load level (%LD) as shown in the picture below
Note :
The values of input (Vin) and output (Vout) voltages read from the LCD of
UPSs or Easy-Mon X from the UPSs in the same network may be different,
even though connected to the same power source. Possible causes of these
happenings are the voltage over each branch circuit is not equal, or ± 1%
accuracy of input and output voltage measuring circuit, or the UPSs are
connected to different power phases of the same source.
- 7 -
- 8 -
