Use
•
Placing the bonnet on to the cushion:
0
1. Turn the waxer/polisher over so that the cushion points
upwards.
0
2. Place a bonnet on to the cushion. Ensure that the bonnet is
central, sits tightly on the cushion and cannot rub on the
housing
.
•
Applying the wax/polish:
0
3. Always use a high quality product for waxing.
·
Follow the working methods given on the packaging.
0
4. Apply the wax/polish directly to the contact surface of the
bonnet.
·
In order to achieve a thin complete covering do not use
more material than is absolutely necessary. Too much
wax does not achieve a better finish and you will have
spent more time later removing the coating.
0
5. Spread the wax evenly over the bonnet. It should also cover
the bonnet edges.
•
Switching on and waxing /polishing the paintwork:
Note: The paintwork to be polished must be first thoroughly
cleaned and fully dry.
If necessary use a commercially available paintwork cleaner.
Use a product suitable for the demands on and condition of
your paintwork. Heavily oxidised paintwork requires a special
cleaner. You should use a combined product (c wax)
for this task.
0
6. Turn the waxer/polisher over again and place it on the
surface to be polished.
·
Make sure that the mains lead cannot come into contact
with the waxer/polisher. Work more safely by guiding the
mains lead over your shoulder.
0
7. Check again that all the safety requirements have been
fulfilled.
0
8. Using both hands firmly grasp the two handles and switch on
the waxer/polisher by pushing down the switch
(see Fig. A).
0
9. Guide the waxer/polisher evenly over the paintwork
(see Fig. B).
·
ATTENTION: Do not press on the waxer/polisher! The
self-weight of the waxer/polisher applies sufficient
pressure for the waxing/polishing process.
·
Any difficult to reach corners or recesses may have to be
completed later by hand. Take the bonnet off the waxer /
polisher and use this bonnet for the corners and recesses.
•
Removing wax or polishing:
10. Use the second bonnet for final polishing or removing the
wax.
·
When working, always follow the instructions given for
the wax/polish.
Cleaning
·
Before cleaning the tool, pull out the plug out of the
mains socket.
·
Clean the housing with a slightly moist cloth. If necessary
use a mild cleaning agent.
·
Clean the bonnet by washing by hand in soapy water.
Use / Cleaning
10
GB
Autopolierer 02.02.2004 14:44 Uhr Seite 10