22
Machine maintenance
As long as the daily, weekly and monthly maintenance procedures are followed, the machine
remains in top working condition. Warning: Risk of electric shock. Disconnect the battery before
servicing the machine.
Daily maintenance (after each use)
1. Drain and clean the recovery tank
2. Remove and flush the floating filter in the recovery tank
3. Drain the water tank and use a hot water tank not higher than 60 °C as needed.
4. Remove the scouring pad/brush for cleaning. If worn, flip or replace the pad
5. Wipe the squeegee strip. Place the squeegee assembly in the raised position to prevent damage
to the strip.
6. Check the wear of the edge of the squeegee blade. If there is any loss, reverse the two ends of
the strip.
7. Wipe the machine with a multi-purpose cleaner and a damp cloth. For safety reasons: do not
spray or water with high pressure when cleaning the machine
Tube flushing machine. So as not to cause electronic parts failure.
8. Check the wear condition of the brush skirt and replace it if it is worn or damaged.
9. Charge the battery. In order to extend the life of the battery and ensure the best performance of
the machine, it must be used in the machine over time.
Battery charging can take more than 30 minutes.
Monthly maintenance (every 80 hours of use)
1. Remove the solution filter from the underside of the machine and clean the filter. Be sure to
empty the solution tank before removing the filter.
2. Clean the top of the battery to prevent electrode corrosion (see "Battery Maintenance").
3. Check if the battery wiring is loose.
Summary of Contents for SJ860
Page 1: ...1 SJ860 Driving floor scrubber User s manual ...
Page 7: ...7 ...