P.S. :
Indicator Light
Power Video
Recording
LED
Light
Ba
�
ery
LED Light Power
Bu
�
on &
Charging
Indicator Light
On
-
-
-
-
-
O
ff
-
-
-
-
-
Charging -
-
-
Red Red
Video & DVR
Power Button
On
Blue
Fast
Blinking
-
-
-
O
ff
-
Blue
-
-
-
Connect
Blinking
Wi-Fi Indicator
Light
On
-
-
Blue -
-
O
ff
-
-
-
-
-
Indicator light and battery
Indicator Light Instruction
WiFi
Battery life description
Status description
Battery charging time
About 5 hours full
About 5 hours
About 2 hours
About 3 hours
About 4 hours
About 3 hours
About 6.5 hours
About 15 hours
Fully charged battery available time
(Only recording)
Fully charged battery available time
(Maximum luminance LED 300 lm + Recording)
Fully charged battery available time
(Maximum luminance LED 150 lm + Recording)
Fully charged battery available time
(Maximum luminance Flashing LED 6Hz + Recording)
Only LED 300 lm
Only LED 150 lm
Only flashing LED lights
Available time
Please use Class 10 or above MicroSDHC Card up to 128GB with the speed of reading and
writing faster than 50MB/s “Media Player Classic Home Cinema” or “KMplayer” is
recommended to play your video on PC.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications not
expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment. (Example - use only shielded interface cables
when connecting to computer or peripheral devices).
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 20 centimeters between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
The antennas used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:(1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may
cause undesired operation.
