Page 11 of 13
LANDING GEAR OPERATION
The following instructions are for Landing Gear Nesting, Deployment and Extension Operations.
Starting with the narrower set of Legs
[
A
] located closer to
the vehicle, pull each Landing Gear Leg downward until both
Engagement Tab’s release [Figure 1, 2 & 3].
Swing Spring loaded Legs to nested position and
release the Engagement Tab into the notch to secure
[Figure 5 & 6].
Repeat for the wider set of legs farthest from the
vehicle.
NESTING LEGS FOR TRANSIT- STEP 1
NESTING LEGS FOR TRANSIT - STEP 2
A
A
A
[Figure 2]
[Figure 1]
[Figure 24]
Engagement
Tab Engaged
A
Engagement
Tab Released
[Figure 3]
[Figure 6]
[Figure 5]
Engagement
Tab Engaged
ONLY TWO LEGS
SHOWN FOR CLARITY
ONLY TWO LEGS
SHOWN FOR CLARITY
C
Never operate the vehicle unless the Landing Gear accessory is fully engaged into the Nested Engagement position.
WARNING:
