Page 8 of 13
STEP 3
STEP 4
13 inches
21 inches
13 inches
21 inches
21 inches
Using two (2) U-Bolts [
L
], two
(2) 1/4” Washers [
N
], and two
(2) 1/4” Nylock Nuts [
M
] each,
attach two (2) Legs [
A
] to the
Carrier’s Frame Bars with
the wheels
facing towards
the vehicle
[Figure 6 & 8] by
slipping the U-Bolts between
the Frame Bars and the carrier
floor panels on the underside
of the carrier.
Legs [
A
] should be each
approximately
13” from the
center of the carrier
.
NOTE: One (1) U-Bolt [L] will
share a slot with a 3/8” x 3/4”
Bolt from STEP 2 as shown
[Figure 7].
Hand-tighten hardware only
at this time for loose fit.
In the same manor as Step 3,
attach the 3rd and 4th Leg [
A
]
facing away from the vehicle
to the carrier Frame Bars using
(2) U-Bolts [
L
], two (2) 1/4”
Washers [
N
], and two (2) 1/4”
Nylock Nuts [
M
] each [Figure 9
& 10].
These Legs [
A
] should be
wider set than the Legs used
in Step 3.
Each approximately
21” from the center of the
carrier
[Figure 11].
Hand-tighten hardware only
at this time for loose fit.
SHOWN WITHOUT CARRIER
FLOOR PANELS FOR CLARITY
SHOWN WITHOUT CARRIER
FLOOR PANELS FOR CLARITY
(REMOVING FLOOR PANELS IS NOT
NECESSARY FOR INSTALLATION)
[Figure 6]
[Figure 8]
[Figure 7]
[Figure 9]
[Figure 10]
[Figure 11]
A
A
L
L
A
A
A
L
L
L
L
A
N
M
Frame Bar
Frame Bar
N
M
N
M
Frame Bar
TOOLS REQUIRED: 7/16IN SOCKET & WRENCH
TOOLS REQUIRED: 7/16IN SOCKET & WRENCH
