Page 3 of 5
STEP 6
DOOR PANELS ATTACHMENT
TAILGATE VEHICLE CONNECTION
FLOOR INSTALLATION (OPTIONAL)
Pull the corners and side flap of the Cover
[G]
underneath
the Steel U-Tube poles
[A]
. [Fg. 10]
At corners: Attach the Ring and Hook together. [Fg. 12]
At side flap: Connect and tighten buckle clip. [Fg. 11]
Pull center bungee tight after all corner connections and
center buckle have been secured. [Fg. 11]
With the Tailgate Connector Panel
[K]
zipped on, place
the Moon Unit against the opening of the vehicle. [Fg. 14]
Depending on the vehicle, Stretch the connector either
over the outside of the vehicle or pull the connector to the
inside of the vehicle opening.
Secured attached Tailgate Connector
[K]
Straps to a
sturdy place on the vehicle (ei. Seat headrests, Handles,
Door Hardware, Tires ect.)
NOTE:
The Tailgate Connector is a universal design
made to fit
most
vehicles. For a more custom fit or for
vehicles with abnormal vehicle opens, hand clamps (not
included) or magnets (not included) are recommended .
Place Floor
[L]
inside of shelter. Connector the Floor to
the Floors Straps
[B],
Steel U-Tube
[A]
and the bottom of
the Cover
[G]
using the attached Velcro as shown.
[Fg.15 ]
The attachment for the Full Door Panel
[H]
, Tent Door
Panel
[J]
, and Tailgate Connector Panel
[K]
are the same.
Starting at one corner, locate the zipper pull on your panel
of choice and zip-on. [Fg. 13]
G
L
B
G
K
G
[Fg. 10]
B
A
[Fg. 12]
[Fg. 14]
[Fg. 13]
[Fg. 15]
HOOK
RING
[Fg. 11]
BUCKLE
ZIPPER
VELCRO
CENTER
BUNGEE
H
J
or
K
A
