Construction, assembly and connection to power supply
Leuze electronic
RS4/AS-i
15
T
N
T
35/
7-
24V
DEUTSCH
ENGLISH
FRANÇAIS
IT
ALIANO
ESPAÑO
L
NEDERLANDS
As the power supply for the PC adapter comes through the PC’s COM port, the latter must
be “RS232 compliant”, that is, with a load of 3 kOhm it must still be able to supply a voltage
of 5 V. The claim to be “RS232-compliant” that is occasionally found with Notebook PCs is
not sufficient here. The RS4/AS-i adapter registers the flow of data in passing, but not does
not act on it in any way. This interface therefore corresponds, in functional terms, to the
RS232 interface connected to the RS4 by means of SUB-D plugs.
Note:
A comprehensive description of the software may be found in the RS4soft User Manual.
4.2
Assembly
Note:
See in this connection chapter 5, “Planning and assembly instructions”, of the RS4-4
Connecting and Operating Instructions.
Note:
To assemble the RS4/AS-i you should use rather long fastening screws, with a length of at
least 50 mm and a diameter of 5 mm; in other respects the assembly instructions for the
ROTOSCAN RS4 laser scanner will apply here as well. The borehole measurements may
be seen from the scale drawings in chapter 7.
Fig. 4.1-3:
Connecting PC and RS4/AS-i with optical PC adapter
