Commissioning and configuration
Leuze electronic
MA 258
i
87
TNT
35/7-2
4
V
Reading out information in service mode
Set the service switch of the gateway to switch position "MA" (
gateway)
.
Send a "v" command to call up all service information of the MA 258
i
.
An overview of the available commands and information can be found in chapter "Reading
out information in Service mode" on page 49.
12.7.1
Specific feature for the use of hand-held scanners
(bar code and 2D devices, combi devices with RFID)
Notice!
For a description of device configuration and the required codes, please see the correspond-
ing documentation at
www.leuze.com.
12.7.1.1 Cable-connected hand-held scanners on the MA 258
i
All hand-held scanners and mobile combi devices available in the Leuze electronic product
line can be used with the corresponding connection cable.
When using the MA 258
i
, the voltage supply of the hand-held scanner (5V/at 1A) can be
connected to the interface by means of a cable via the 9-pin Sub-D connector (voltage on
PIN 9). The corresponding cable is to be selected for the respective hand-held scanner and
ordered separately. The 9-pin Sub-D cable (KB JST-HS-300, part no. 50113397) is
connected to this cable, which is connected to the MA 258
i
. This cable must also be ordered
separately.
In this example, triggering occurs by means of a trigger button on the hand-held scanner.
12.7.1.2 Wireless hand-held scanners on the MA 258
i
All wireless hand-held scanners and mobile combi devices available in the Leuze electronic
product line can be used with the corresponding connection cable via the base station.
A 230VAC connection (socket) is usually necessary for the charging station. Here, a data
connection of the charging station is established with the MA 258
i
. The corresponding cable
is to be selected for the respective hand-held scanner and ordered separately. Connect this
cable to the 9-pin Sub-D cable (KB JST-HS-300, part no. 50113397), which is connected
to the MA 258
i
. This cable must also be ordered separately.
In this example, triggering occurs by means of a trigger button on the hand-held scanner.
The following codes for configuring the devices are necessary for these devices as well.
