Installation and mounting
34
MA 258
i
Leuze electronic
6.3
Device arrangement
Ideally, the MA 258
i
should be mounted so that it is easily accessible near the Ident device
in order to ensure good operability, e.g., for configuring the connected device.
6.3.1
Selecting a mounting location
In order to select the right mounting location, several factors must be considered:
• The permissible cable lengths between the MA 258
i
and the host system depending
on which interface is used.
• The housing cover should be easily accessible, so that the internal interfaces (device
interface for connecting the Leuze device via PCB connectors, service interface) and
other operational controls are easy to reach.
• Maintaining the required environmental conditions (temperature, humidity).
• Lowest possible chance of damage to the MA 258
i
by mechanical collision or jammed
parts.
6.4
Cleaning
Clean the housing of the MA 258
i
with a soft cloth after mounting. Remove all packaging
remains, e.g. carton fibers or Styrofoam balls.
Attention!
Do not use aggressive cleaning agents such as thinner or acetone for cleaning the device.