Status displays and operational controls
48
MA 258
i
Leuze electronic
8.2.5
Rotary switch S4 for device selection
The
S4
rotary switch is used to select the Leuze end device.
Figure 8.5:
Rotary switch for device selection
The following switch positions are assigned to the Leuze devices:
The gateway is set via the switch position on the Leuze device. If the switch position is
changed, the device must be restarted, since the switch position is only queried after
switching off completely and then restarting the device.
Notice!
In switch position "0", a distance of >20ms must be maintained between two telegrams so
they can be distinguished from one another.
The parameters of the Leuze end devices are described in chapter 16.
Leuze device
Switch position
Leuze device
Switch position
Standard setting
Other RS 232 devices such as
KONTURflex QUATTRO
0 LSIS 4x2i,
DCR 202i
7
BCL 8 1
Hand
scanner
8
BCL 22 2
RFID (RFI xx,
RFM xx, RFU xx)
9
n.c.
3 BPS 8
A
BCL 300i, BCL 500i,
BCL 600i
4
ODS 9, ODSL 30, ODSL 96B,
BPS 300i
B
BCL 90, BCL 900i
5
MA 3x
C
LSIS 122, LSIS 222
6
Reset to factory setting
F
