Installation
Leuze electronic GmbH + Co. KG
BPS 37
17
6
Installation
6.1
Storage, transportation
Unpacking
Check the packaging content for any damage. If damage is found, notify the post office or shipping
agent as well as the supplier.
Check the delivery contents using your order and the delivery papers:
• Delivered quantity
• Device type and model as indicated on the name plate
• Accessories
• Operating instructions
Save the original packaging for later storage or shipping.
If you have any questions concerning your shipment, please contact your supplier or your local Leuze elec
-
tronic sales office.
Observe the applicable local regulations when disposing of the packaging materials.
Cleaning
Clean the glass window of the BPS 37 with a soft cloth before mounting. Remove all packaging remains,
e.g. carton fibers or styrofoam balls.
6.2
Mounting
Accessories
The mounting system BT 56 is available for installation. It may be ordered separately from Leuze elec
-
tronic. For order numbers, see Table 5.1 "Accessories/order codes" on page 14.
Mounting the BPS 37
There are two basic types of mounting arrangements for the BPS 37:
• Using the dovetail groove and the corresponding mounting accessories see figure 6.1
• Using the mounting threads on the rear and bottom of the device (Chapter 4.3)
ATTENTION!
Package the device for transport and storage in such a way that is protected against shock and
humidity. Optimum protection is achieved when using the original packaging. Ensure
compliance with the approved environmental conditions listed in the specifications.
ATTENTION!
Do not use aggressive cleaning agents such as thinner or acetone for cleaning the device and
bar code tape.
