Max. Connection
Leads Diameter
2,5 mm2
EMC
According to: PN-EN 61326-1
4. DEVICE INSTALLATION
The unit has been designed and manufactured
ensuring
a high level of user safety and resistance to
interference
that may
occur
with
in a typical industrial environment. In order to take full advantage of
these characteristics
the
installation of the unit must be conducted correctly and according to the
local regulations.
Loop Powered Display
250 SERIES
04
This is a class A unit. In a residential or a similar area it can cause radio frequency
interference. In such cases the user can be requested to use appropriate preventive
measures.
4.1. UNPACKING
After removing the unit from the protective packaging, check for transportation damage. Any
transportation damage must be immediately reported to the carrier. Also, write down the unit serial
number on the housing and report the damage to the manufacturer.
4.2. ASSEMBLY
To install device on the wall, a pinholes
s h o u l d b e m a d e . F i g u r e 4 . 1 p r e s e n t s
dimensions of the device and distances
between holes. The back side of the device
has four mounting holes. This part of the
c a s e s h o u l d b e m o u n t e d t o a w a l l b y
screws.
Disconnect the power supply prior to starting assembly.
Check the connections are wired correctly prior to switching the unit on.
User's Manual,
Warranty,
Included
with the unit
Installation should be conducted by qualified personnel.
Read the basic safety requirements on page 3 prior to starting the installation.
All installation works must be conducted with a disconnected power supply.
5
D