Level Pro ITC 450 User Manual Download

Page: 27 / 59

www. levelprosales.com

7.2.2. Numeric parameters (slide change mode)

In “slide change” mode („Edit”=”Slid”), buttons [^] and [v] has different functions.
       To increase edited value press (or press and hold) [^] button only, the increasing became quickest as
long as button [^] is pressed. To slow down the increasing, button [v] can be used. If [v] is pressed shortly
(and  button  [^]  is  still  pressed),  increasing  slow  down  for  a  moment  only,  if  [v]  is  pressed  and  held  while
button [^] is still pressed the increasing slow down and will be kept on lower speed.
         To decrease edited value press (or press and hold ) [v] button only. The decreasing became quickest as
long as button [v] is pressed. To slow down the decreasing, button [^] can be used. If [^] is pressed shortly
(and button [v] is still pressed), decreasing slow down for a moment only, if [^] is pressed and held while
button [v] is still pressed the decreasing slow down and will be kept on lower speed.
         Press [ENTER] at least 2 seconds to accept the changes, after that question ”Set?” is displayed, and user
must to confirm (or cancel) the changes. To conform changes (and story it in EEPROM) press [ENTER] button
shortly after ”SEt?” is displayed. To cancel the changes press [ESC] button shortly after ”SEt?” is displayed.
After that device returns to the menu.

7.2.3. Switch parameters (“LIST” type)

Switch parameters can be described as a sets of values (a lists) out of which only one of the options
available on the list can be selected for the given parameter. Options of switching parameter are selected
using [^], [v] keys.
Short pressing of [ENTER] causes in displaying of the acknowledge question (”SEt?”). If key [ENTER] is
pressed again, the changes are accepted, stored in EEPROM end the edition process finished. Pressing the
key [ESC] after ”SEt?” causes in cancelling of made changes and returning to menu.

While editing numeric parameter:
• Change of current (flashing) digit
• Slide change of value (acceleration, deceleration, direction change)
While editing switch parameter - selection of switch parameter.

Functions of buttons when editing numeric and switching parameters:

MENU

ESC

ENTER

If numerical parameter is being edited, a short quick pressing of [ENTER] button will
change edited position. A long press of [ENTER] button (at lest 2 sec.) the display to

request

”SEt?” confirm, which allow user to make sure the change of the parameter

value is correct. If switch parameter is being edited, a short press of [ENTER] button
causes the display a ”SEt?” confirmation. When [ENTER] button is pressed again (while
”SEt?” is displayed) the new value of the parameter is stored in EEPROM memory.

Pressing this button the operator can cancel the changes done up to now (if they
were not approved by [ENTER] button after the ”SEt?” request) and will return to
the main menu. menu.

www. levelprosales.com

ITC 450/470

User manual