Level GB 060 515 C, User Manual

16

3.3. Hints for Installation

ED 001 002 - GSM antenna 

Install on inside of windows or plastic places under dashboard. Fix with adhesive
tape.

Never stick to metal parts of vehicle body, do not place near alarm sensors - chance
of false alarms and near the cables and car radio – chance of interferences.

ED 002 002 - GPS antenna 

Install horizontally under dashboard, under plastic cover of air inlet or in plastic
bumpers. Ensure the best possible view of the sky – the view cannot be covered by
metal objects. Be aware of glass coated with metal in windows – GPS signal doesn’t
go through them.

ED 060 600 - LED

Install in lower part of dashboard so the LED signalization does not disturb the
driver. Use 6 mm drill.

ED 060 601 - Emergency button

Install on lower side post on the driver side or under dashboard. Use 7 mm drill.

ED 060 605 - Alarm siren

Install in upper parts by the engine, point the output to the ground. 

ED 060 620 - Wireless access card receiver

Bundle with cables near the car alarm unit.

ED 060 619 - Ultrasonic motion sensor

Install the transmitted and receiver on the side posts of windshield, install the unit
close to the car alarm unit.

Sensor is powered only when vehicle is armed so when ignition is on, the ultrasonic
signal is not transmitted into cabin.

Sensor can also be activated by air flow, e.g. when windows are open. Due to this, it
is not possible to use sensor in vehicles with automatic air conditioning.

ED 060 611 - Microwave motion sensor

Install in the middle of vehicle, in the tunnel between seats or on the ceiling. Set the
sensor sensitivity so it only detects a person entering the cabin.

ED 060 618 - Tilt sensor

Install in linear or cross direction close to the cabin floor.

ED 060 606 - Hood sensor

Install so the sensor trimmer is disconnected from the frame when hood is closed.