EN
14
MAINTENANCE
WARRANTY AND RESPONSIBILITY
•
Handle measuring devices with care.
•
Clean the device after every use with a soft cloth. If
nessesary, dampen the cloth with water.
•
If the instrument gets wet, clean it and dry it carefully.
•
Only put the laser away when it is completely dry.
•
Remove the batteries and rechargeable batteries when
switching off the aser for a long time.
•
Do not use solvent to clean the laser.
•
Only transport the laser in its original case.
The 860H is not watertight or airtight.
Do not get it wet, as this may damage
the internal circuits. Do not leave it in direct
sunlight or exposed to high temperatures. The laser body and
some internal parts are made of plastic and can warp at high
temperatures. Do not store the laser in a very cold environment,
as this can cause condensation to form on the internal
parts when the laser is warmed up. This can mist up the beam
windows and cause the internal circuit boards to rust.
NEVER STORE AN INSTRUMENT IN WET
CONDITIONS IN A CLOSED CASE!
POSSIBLE ERRORS
If the measurements calculated by the laser are incorrect, this
could have been caused by:
•
Using the laser near to plastic or glass windows (may give
false information).
•
A dirty or obstructed beam window.
•
A slight movement of the device. If this is the case, check
the precision of the device once more.
•
Signifficant temperature diffrences: if the laser is used
in a cold environment after being stored in a warm envi-
ronment, wait a few minutes for the laser to reach room
temperature before carrying out any measurements.
The device has a two-year warranty. This warranty does not
cover breakdowns or faults which may have been caused by:
•
Incorrect use of the device.
•
Non-respect of the instructions described in the user-
manual.
•
Offcuts, poor handling, use of unsuitable batteries, poor
electrical connections etc.
Repairs made other than by our factory, our service centres
or authorized service stations relieve our company of further
liability under this guarantee. This warranty is made expressly
in place of all other warranties, expressed or implied, with
respect to quality, merchantability, or fitness for a particular
purpose.
THE USER MUST CHECK THE DEVICE
REGULARLY AND BEFORE CARRYING OUT
SUBSTANTIAL WORK.
Levelfix company shall accept no responsibility for problems
regarding the construction, installation, manufacture
or assembly which may result from a machine failure due to
poor maintenance of the device or hazardous connections to
other devices.
BATTERY REPLACEMENT
The 860H works with a NIMH battery pack which can be placed
on the front of the instrument. Slide the red lock knob all the
way to the right to remove the battery. To lock the battery, slide
the red slider to the middle position and to charge all the way
to the left, the charging plug will then be accessible. Charge the
battery at least once every 180 days!
If the battery voltage is too low, the battery indicator on the
keyboard will light up red. Always charge the battery with the
original charger supplied.
