FNC-0107TX 10/100Mbps Fast Ethernet Adapter
8
BIOS Configuration
Due to a fault in some Plug-n-Play BIOS
programs, it happens occasionally that a newly
installed adapter is assigned an Interrupt Number
which is already assigned to another device. In
such a case, the conflict of Interrupt Number will
cause faults in the behavior of both devices.
Then it is necessary to run the CMOS Setup
utility, and manually assign a non-conflicting
Interrupt Number.
Driver Installation
Before you connect the FNC-0107TX
10/100Mbps Fast Ethernet Adapter to the
network, you have to install the network driver
first. The driver for each networking operating
system is under a separate directory. A
HELP8139.EXE file under root directory lists
the information and detailed installation
procedure of all the available drivers.
Boot ROM Installation
The optional Boot ROM device allows you to
connect a diskless workstation to the network.
Perform the following steps to install your Boot
ROM device:
1.
Insert the Boot ROM into the socket on the
Card.
