Level One Printer Servers
Configuration Methods
To support the widest possible range of users , the LevelOne Printer Server is supplied with
the utilities listed in the following table.
Note that this document covers only BiAdmin with Novell's Client 32 software installed on
your PC. For more details about the other methods, refer to the full User Manual on the
CD-ROM.
BiAdmin
If possible, you should use the supplied BiAdmin utility for
configuration. BiAdmin is a powerful, user-friendly program which
runs under Windows 95/98/NT.
See
Chapter 4 - BiAdmin Utility
for details on installing this program,
and general instructions on usage.
BiAdmin works best if you have Novell NetWare Client 32 for
Windows installed.
Quickset
QUICKSET is a DOS-based command-line program. It will configure
the LevelOne Printer Server and the current Novell server in a single
operation. However, it provides few options.
PSConfig
PSConfig is a DOS-based, menu-driven program. It uses the IPX/SPX
protocol to connect to the LevelOne Printer Server, so your PC must
load the IPX/SPX drivers before PSConfig can be used.
PSConfig can only configure the LevelOne Printer Server itself. You
must use the NetWare’s PCONSOLE or NWAdmin to configure the
NetWare server.
- 20 -
