For models with bracket ring clamps:
Remove the ring clamps from the telescope tube by releasing their thumb nuts and opening their
hinges. Fasten the bracket with ring clamps to the mount through one of three holes. To lock the
bracket, rotate the black riffled wheel inside the mount base. Place the telescope tube between
the rings and balance it. Close the hinges around the telescope and retighten the thumbscrews.
Do not overtighten.
Assembling slow-motion controls:
attach the slow-motion controls to the worm gear
mechanisms and tighten the locking screws.
Finderscope assembly:
insert the finderscope base into the bracket on the
tube and tighten locking screws.