11
To control your switch with your phone, add it to a compatible
Zigbee hub. Use the hub's app and follow the instructions for
adding a switch. When you power up your switch it immediately
enters inclusion mode (some hubs may use the term connect
or pair).
If the hub uses older inclusion processes contact technical
services for specific product instructions.
Add your switch to a hub
When you first power on your switch or
perform a factory reset the green status light
will automatically flash. This indicates the
switch is in joining mode. It will remain
in this state for 30 minutes or until
the switch is added to a network.
To manually start or stop joining mode
perform the following steps:
1.
Hold the top of the paddle for 7 seconds.
Status light will turn amber.
2a.
To start joining mode tap the top of the paddle 1 time. The
status light will flash green rapidly to indicate it is in joining
mode.
2b.
To stop joining mode tap the top of the paddle 1 time. The
switch will leave joining mode. NOTE: the device can still be
operated manually even if not joined to a hub.
Manually start/stop joining
To control your switch with your phone, add it to a compatible
Zigbee hub. Use the hub's app and follow the instructions for
adding a switch. When you power up your switch it immediately
enters inclusion mode (some hubs may use the term connect, join,
or pair).
If the hub uses older inclusion processes contact technical
services for specific product instructions.
WEB
VERSION
Summary of Contents for Decora Smart DG15S
Page 1: ...Getting Started Guide Cat No DG15S SWITCH WEB VERSION...
Page 2: ...WEB VERSION...
Page 15: ...WEB VERSION...