Insert Iris or
Gobo Holder
Gobo Slot
Iris Slot
Rear Lens
Front Lens
5
BEAM SHAPING
The LED Follow Spot light can be shaped as follows:
• Drop-in Iris Pattern
• Drop-in Gobo Pattern
• Variable Beam*
* Variable beam is altered by adjusting the front and rear zoom lenses in relation to one another.
The front lens defines the beam spread. The rear lens controls the softness or hardness of the beam edge.
OPERATION
For standard operation, connect the LEO™ LED Follow Spot to a power source (100-240VAC single phase). To switch ON,
press the POWER button at the back of the fixture. The red status indication lamp (POWER) on the control panel will light up
when power is applied.
NOTE: The fixture is equipped with two fans to aid in the cooling process. They are designed to vary their velocity at different
operating temperatures. Ensure vents are clean to maintain proper cooling. Avoid touching the fixture's housing as it may
become hot during use.
TO DIM
• To decrease light output, turn the dimming knob
counterclockwise to DIM.
• To increase light output, turn the dimming knob
clockwise to BRIGHT. The green status indication
lamp (DIM) on the control panel will light up
according to the intensity of the light output.
POWER
DIM
DIM
BRIGHT
PRESS
STROBE LIGHT EFFECT
POWER
DIM
DIM
BRIGHT
PRESS
STROBE LIGHT EFFECT
STROBE
• To begin, press and hold the STROBE button.
• Release the STROBE button to stop the effect.
Light output will be resumed to the previous setting.
CONTROL INTERFACE (located on side of fixture)
