Page 5 of 8
PK-93777-10-02-0C
To open the door: Lift tabs as shown
To remove cover: Push tabs down, and
then slide the cover out.
COVER REMOVAL
DOOR LATCH
CABLE INSTALLATION - PREPARATION (SLIDING TRAY)
Multi-Strand
Secure to Enclosure
Secure to Tray
Top View: Tray to Front
NOTE:
Tray in forward position, covers
and center bar removed for clarity.
NOTE:
• Route cable to tray through grommet on the opposite
side of cable entry.
• Plan for cable routing prior to termination.
• Adjust fiber ring kit based on desired application (see
page 6 for detail).
• Assure cable slack for tray movement.
• For additional cable slack management, use optional
Fiber Management Ring Kit (5R100-14R).
To remove tray from enclosure, lift rear tray plunger, slide tray
fully rearward.
Pictured: Removable tray to facilitate field
termination and splicing
NOTE: Grounding lug can be used to secure
cable to enclosure.
Caution
:
If grommet needs to
be cut, cut at an angle
towards the center
and on the inside of
the grommet only.
NOTE:
Cutting beyond the pre-determined cutting
guides or through the grommet edge may cause
deformation of the grommet and decreased retention
capability.
CABLE GROMMET
