1
How to Install Custom Vertical Valance
How to Install Custom Vertical Valance
VALANCE STYLES
The following illustrations show installed examples of some common valance styles. Refer to the installation that matches your valance.
Designline
™
Valance
Traditional Valance
Transitional Valance
Visions
™
Faux Wood Valance
BEFORE YOU BEGIN:
Please refer to the illustrated examples to determine which clips and instructions you will need.
Twist-lock Valance Clips
Visions
™
Valance Clips
INSTALLING VALANCE CLIPS
STEP A
Install the valance clips — DesignLine
™
, Traditional and Transitional
(outside-mount)
• NOTE: Headrail mounting shown in installed position to show
typical mounting bracket locations.
• Position one clip at each end of the headrail next to the headrail
mounting bracket locations. Make sure that the clips do not
interfere with the mounting brackets.
• Lower the clip into the top channel of the headrail at 45° angle
to the headrail so the locking tabs fit into the channel.
• Rotate the clip in the channel so that it locks into place.
• Space remaining clips evenly between the ends, not more than
30" apart.
STEP B
Install the valance clips — DesignLine
™
, Traditional and Transitional (inside-mount)
• NOTE: Valance clips must be installed prior to headrail installation.
• Position one clip at each end of the headrail, next to the headrail mounting bracket
locations. Make sure that the clips do not interfere with the mounting brackets.
• Lower the clip into the top channel of the headrail at a 45° angle to the headrail so
the locking tabs fit into the channel.
• Rotate the clip in the channel so that it locks into place.
