11
ADDITIONAL PROGRAMMING
Remote Control Guide
NOTE:
Without any additional programming, this remote
will now operate the same set of window coverings and
GROUPS as the original remote OR use the instructions on
page 8 to “Join a shade to a group” to program the second
remote differently from original, to control a different set of
shutters and/or different GROUPS.
RESET WINDOW COVERING PROGRAMMING
This reset erases all programming stored in the window
covering, including GROUP assignments, preventing any
remote from operating the window covering. Reset window
covering program is used during installation to correct
GROUP assignments.
Note:
This reset does not affect travel limits.
1. Press and hold the manual control button, located
on the window covering headrail. Continue to hold
the manual control button until the window covering
moves slightly up and down TWO times. This indicates
the window covering programming has been reset.
2. Release the manual control button.
3. Refer to “Join a window covering to a GROUP” on
page 8, to program the window covering to a group.
RESET TRAVEL LIMITS
1. Press and hold the manual control button, located
on the window covering headrail, until the window
covering moves slightly up and down ONE time.
This indicates that the limits have been reset.
2. Release the manual control button.
3. The window covering will now move on its own
to set both the top and bottom motor limits.
Once this process is done, the window covering
will move briefly in both directions.
RESET REMOTE
Removes any connections previously programmed between
the remote and any window coverings.
• Using a paper clip, BRIEFLY press the remote
reset button.
Previously paired window covering(s) will no longer operate
with this remote.
