GETTING STARTED
3
CONTENTS
2
© 2019 LEVOLOR
®
, Inc.
Getting Started:
Product View ............................................................................................ 3
Tools and Fasteners Needed .................................................................. 4
Installation:
Installation Overview ................................................................................5
Mount the Installation Brackets — Inside Mount ............................ 6 – 7
Mount the Installation Brackets — Outside Mount ......................... 7 – 9
Mount the Installation Brackets — Side Mount ..................................... 9
Install Batteries & Connect the Power Source ............................. 10 – 11
Install the Shading ..................................................................................12
Attach the Magnetic Hold-Down Brackets (Optional) ................ 12 – 13
Operation:
Operate the Shading ..............................................................................13
Resetting the Shading ............................................................................ 14
Troubleshooting .............................................................................. 15 – 19
Care:
Removing the Shading .......................................................................... 20
Cleaning Procedures ..................................................................... 20 – 21
Warranty
.................................................................................................21
Product View
Remote
(Optional)
Satellite Battery Pack
(optional)
Satellite Battery Pack
Headrail
Headrail
End Cap
End Cap
Magnetic
Hold-Down
Bracket
(Optional)
Installation
Bracket
Limit Stop
Bottom Rail
Standard
Battery
Battery Pack
Clips
Battery Pack
Cable
Manual
Control
Button
ALL
1
2
3
4
5
6
Battery-Powered Motorized Operating System
Battery-Powered Motorized Operating System
Wall Mount Bracket
Battery Pack Cover
Extension
Cable
Socket
Radio Frequency FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Industry Canada
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum
(or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more
than that necessary for successful communication.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Class B Digital Device Notice
This Class B digital apparatus complies with Canadian ICES-003, RSS-Gen and RSS-210.
Wall Mount
Bracket
18-0053-026_Sheer_Motorized_Install_Guide_F_wu.indd 2-3
2/26/19 10:37 AM
