99
Appendix C: CPC-Car Power Control
For OEM CPC function only
Introduction:
Operation
CPC-Car Power Control
CPC is designed speci
fi
cally for the car, with the over-current protection.
Acceptable input 9V ~ 36V wide voltage input, and can prevent momentary surge caused by
excessive input voltage causes damage to the motherboard parts protection mechanisms,
and there are, input power protection device to prevent reverse the negative.
CPC can be set when the output power or when to turn off the power when the car is started
and shut down time, and when the car out of battery power will be automatically cut off the
output power to protect the battery. When not in use the current consumption of approximately
<2mA to protect the vehicle battery will not be too much load current of the battery is dead
There are two modes operating: Auto Mode and Manual Mode.
The default setting is "Auto Mode"
SC1 CPC & Control mode switch.
SC1: Board Top view
Note: 1.If CPC was disabled which have not under low voltage protection and timing delay function and
power output continually until the out of car battery.
2. In Auto Mode. Can’t setting OS Delay off timer.
3. Default, CPC function enabled, Mode is Auto
4. It need reset power when switch setting
fi
nish.
5. default setting 1 - 2 ON
1
2
CPC function
Mode select
Up
Up
CPC Enabled
Auto
Down
Down
CPC Disabled
Manual
