Lexicon
MPX R1 User Guide
2-2
Loading Programs
Use the BANK buttons to select a
bank number. The first two digits
on the display show your selection
— bank 23 in this example.
Press one of the switches num-
bered 0-9 to select a program within
the selected bank. The third digit
shows our selection — program 5.
Direct Access Mode
You can also enter program numbers directly in Direct Access Mode. Press and
hold the FX button until its LED begins blinking. The display will flash d-A to
indicate that Direct Access Mode is active. Now you can select programs by
directly entering their program numbers. For example, to load MPX 1 Program
135, press 1, then 3, then 5 on the MPX R1.
In this mode, the BANK buttons increment and decrement the program numbers
in consecutive steps.
Press the FX button once to exit to FX Mode, twice to exit to Program Mode.
The first two digits on the display indicate the bank number. The third digit
indicates the program number. The BANK buttons select banks, and switches
0-9 select programs within the displayed bank. Programs are loaded whenever
one of the numbered switches is pressed.
To load a new program within the same bank, press any of the numbered
switches (0-9).
To select a program in a different bank, press the BANK buttons to step to the
bank you want, or hold down either button to scroll through the numbers. The
rightmost digit, which is reserved for program numbers, will turn off during bank
selection. Once you have selected the desired bank, press the numbered switch
to load the program number within that bank.
