6
Press .
7
To change the number of times the printer will redial:
a
Press
or
repeatedly until
Redial Attempts
appears.
b
Press .
c
Press
or
repeatedly until the setting you want appears.
d
Press .
8
To change the length of time between redials:
a
Press
or
repeatedly until
Redial Time
appears.
b
Press .
c
Press
or
repeatedly until the setting you want appears.
d
Press .
Schedule to resend fax at a later time
See “Sending a broadcast fax at a scheduled time” on page 115.
Failed to Connect
These are possible causes and solutions. Try one or more of the following:
Use phone line checklist
•
Resend the fax. There may have been a problem with the quality of the telephone line connection.
•
Place a test call to the telephone number to which you want to send a fax to make sure that it is working correctly.
•
If the telephone line is being used by another device, wait until the other device is finished before sending the
fax.
Make sure the printer detects dial tone
•
See “Sending a fax while listening to a call (On Hook Dial)” on page 115.
•
Check the Dial Method setting.
1
Listen for a dial tone. If you hear a dial tone, but the printer hangs up without dialing, this means it did not
recognize the dial tone.
2
From the control panel, press
Fax Mode
.
3
Press
.
4
Press
or
repeatedly until
Fax Setup
appears.
5
Press .
6
Press
or
repeatedly until
Dialing and Sending
appears.
7
Press .
8
Press
or
repeatedly until
Dial Method
appears.
9
Press .
10
Press
or
repeatedly until the method you want appears.
11
Press to save this setting.
190
