Repair Information 4-9
4091-001
Rear Cover Removal
1. Remove the screws from the bottom assembly.
2. Remove the front cover.
3. Pry upward on the two rear cover latches.
4. Work the tabs of the rear cover free from the base assembly.
5. To reassemble, place the cover over the tabs in the base
assembly and press toward the front of the machine until the
cover latches. Be sure the parallel connector snaps do not get
trapped behind the cover.
Sheet Feeder Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Remove the two sheet feeder mounting screws from the rear of
the carrier frame.
4. Unlatch the right sheet feeder latch from the front of the carrier
frame.
Note: For reassembly. The cables are routed through tab slots
in the sheet feeder.
5. Remove the sheet feeder.
Small Feed Roll Assembly Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Remove the sheet feeder.
4. Remove the system board.
5. Remove the four small feed roller springs from the carrier frame.
6. Push down on each of the small feed roll assemblies to remove
them from the small feed roll bracket.
Summary of Contents for 2030
