1
Notch
2
Ridge
5
Push the memory card straight into the connector until it
clicks
into place.
1
2
6
Reattach the system board cover.
Installing a flash memory or firmware card
The system board has two connections for an optional flash memory or firmware card. Only one of each may be installed,
but the connectors are interchangeable.
CAUTION—SHOCK HAZARD:
If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the
wall outlet before continuing. If you have any other devices attached to the printer, then turn them off as well,
and unplug any cables going into the printer.
Warning—Potential Damage:
System board electronic components are easily damaged by static electricity. Touch
something metal on the printer before touching any system board electronic components or connectors.
1
Access the system board.
For more information, see
“Accessing the system board” on page 21
Notes:
•
This task requires a flathead screwdriver.
•
Do not unplug the fan cable upon opening the metal panel.
2
Unpack the card.
Note:
Avoid touching the connection points along the edge of the card.
Additional printer setup
25
