Setting up and using the accessibility features
Enabling Magnification mode
1
From the control panel, press and hold the
5
key until you hear a voice message.
2
Select
Magnification
.
3
Select
OK
.
For more information on navigating a magnified screen, see
“Navigating the screen using gestures” on
Activating Voice Guidance
From the control panel
1
Press and hold the
5
key until a voice message is heard.
2
Select
OK
.
From the keyboard
1
Press and hold the
5
key until a voice message is heard.
2
Press
Tab
to navigate the focus cursor to the OK button, and then press
Enter
.
Notes:
•
Voice Guidance is also activated by inserting the headphones into the headphone jack.
•
To adjust the volume, use the volume buttons at the bottom part of the control panel.
Adjusting the Voice Guidance speech rate
1
From the home screen, select
Settings
>
Device
>
Accessibility
>
Speech Rate
.
2
Select the speech rate.
Adjusting the default internal speaker volume
The speaker volume will reset to default value after the session is logged out, when the printer wakes from
Sleep or Hibernate mode, or after a power
‑
on reset.
1
From the control panel, navigate to:
Settings
>
Device
>
Preferences
>
Audio Feedback
2
Select the volume.
Note:
If Quiet Mode is enabled, then audible alerts are turned off.
Setting up and using the accessibility features
19
Summary of Contents for CS921
