Maintaining the printer
Warning—Potential Damage:
Failure to maintain optimum printer performance periodically, or to replace
parts and supplies, may cause damage to your printer.
Networking
Note:
Purchase a MarkNet
TM
N8370 Wi-Fi option first before setting up the printer on a wireless network. For
information on installing the Wi-Fi option, see the setup sheet that came with the option.
Connecting the printer to a wireless network using Wi
‑
Fi Protected Setup
(WPS)
Before you begin, make sure that:
•
The access point (wireless router) is WPS
‑
certified or WPS
‑
compatible. For more information, see the
documentation that came with your access point.
•
A wireless network adapter is installed in your printer. For more information, see the instructions that came
with the adapter.
Using the Push Button method
1
From the control panel, navigate to:
Settings
>
Network/Ports
>
Wireless
>
Wi
‑
Fi Protected Setup
>
Start Push Button Method
2
Follow the instructions on the display.
Using the personal identification number (PIN) method
1
From the control panel, navigate to:
Settings
>
Network/Ports
>
Wireless
>
Wi
‑
Fi Protected Setup
>
Start PIN Method
2
Copy the eight
‑
digit WPS PIN.
3
Open a Web browser, and then type the IP address of your access point in the address field.
Notes:
•
View the printer IP address on the printer home screen. The IP address appears as four sets of
numbers separated by periods, such as 123.123.123.123.
•
If you are using a proxy server, then temporarily disable it to load the Web page correctly.
4
Access the WPS settings. For more information, see the documentation that came with your access
point.
5
Enter the eight
‑
digit PIN, and then save the changes.
Maintaining the printer
33
Summary of Contents for CS921
