Photo menu
The following Photo options will not time out after two minutes of inactivity or after you
turn off the printer, but they will return to the factory default settings when a memory
card or flash drive is removed.
•
Photo Effects
•
Photo Size
•
Layout
•
Quality
To change the temporary settings into new default settings
1
From the printer control panel, press
.
2
Press the arrow buttons to scroll to
Defaults
, and then press
.
3
Press the arrow buttons to scroll to
Set Defaults
, and then press
.
Use Current
appears on the display.
4
Press
again to select
Use Current
.
5
Press
until you exit Setup, or press another mode button.
To disable the settings timeout feature
You can disable the settings timeout feature if you do not want the printer to revert to the default settings after two
minutes of inactivity or after the printer is turned off.
1
From the printer control panel, press
.
2
Press the arrow buttons to scroll to
Device Setup
, and then press
.
3
Press the arrow buttons to scroll to
Clear Settings Timeout
, and then press
.
4
Press the arrow buttons to scroll to
Never
, and then press
.
5
Press
until you exit Setup, or press another mode button.
Changing the Power Saver timeout
The Power Saver timeout is the time it takes for the printer to switch to Power Saver mode when the printer is left
idle. The Power Saver feature optimizes energy efficiency by reducing the printer power consumption (as much as
28 percent on some printer models) compared to the default printer settings. To save the most energy, select the
lowest Power Saver timeout.
1
From the printer control panel, press
.
2
Press the arrow buttons to scroll to
Device Setup
, and then press
.
3
Press the arrow buttons to scroll to
Power Saver
, and then press
.
4
Press the arrow buttons to select a Power Saver timeout, and then press
.
5
Press
until you exit Setup, or press another mode button.
Using the printer control panel buttons and menus
16