PCL
2-74
Table 2-31: Font Creation
Command / Parameters
Function / Result
ESC
*c#D
# = Font ID # (0 - 32767)
Default = 0
Set Font ID
Sets the identification number for the font being downloaded.
ESC
)s#W[data]
# = number of data bytes
Load Font Header
Downloads soft font header information.
Note: Set Font ID before using this command.
ESC
*c#F
0
Delete all (temporary and permanent)
1
Delete all temporary
2
Delete previous font ID
3
Delete previous specified character
4
Make previous font ID temporary
5
Make previous font ID permanent
6
Copy current font
Caution: Font Control
Manages soft fonts.
ESC
*c#E
# = Code Point (0 - 65536)
Default = 0
Set Character Code
Sets the decimal code point associated with the next character
downloaded or deleted.
ESC
(s#W[data]
# = number of data bytes
Load Character
Downloads character descriptor and data to the current character
code.
Table 2-32: Macros
Command / Parameters
Function / Result
ESC
&f#Y
# = Macro ID (0 - 32767)
Default = 0
Set Macro ID
Sets the ID for the macro you have created on flash or disk.
ESC
&f#X
0
Start definition
1
End definition
2
Execute macro (previous macro ID)
3
Call macro (previous macro ID)
4
Enable overlay (previous macro ID)
5
Disable overlay
6
Delete all macros
7
Delete all temporary macros
8
Delete current macro ID
9
Make last ID temporary
10
Make last ID permanent
Macro Control
Manages use of macros.
Notes:
• GL/2 commands are supported inside macros.
• Only call and execute macro commands are allowed within a macro.
• A macro may call or execute another macro. This is called nesting. A
maximum of two nesting levels are allowed, for a total of three
levels.
See “Macros” on page 2-96 for additional information.
