Diagnostic Aids
3-19
4069-XXX
Print Registration
The print registration range is as follows:
Bottom Margin: -20 to +20 Each increment causes
approximately.55 mm shift in the bottom margin.
Top Margin: -25 to +25
Left Margin: -25 to +25
Right Margin: -10 to +10
To set Print Registration:
1. Select Registration from the Diagnostic menu.
2. The Top margin sign/value pair blinks. This indicates it is the
margin value being changed.
3. To select the margin value to be changed press Select until the
margin value pair you want to change is blinking.
4. To change the margin value press either Menu> or <Menu.
When the value you want is displayed, press Select to save the
value.
5. To exit the Registration menu, press Return.
To verify the margin values are correct you must print the "Quick Test
Page" from the registration screen. Press Go to print the test page.
While printing the Quick Test Page the “Quick Test Printing”
message displays. Once the Quick Test Page completes printing,
the Registration screen displays again.
The "Quick Test Page" should be printed on letter or A4 paper.
