147
•
Your product uses a printing process that heats the print media, and the heat may
cause the media to release emissions. You must understand the section in your
operating instructions that discusses the
guidelines for selecting print media
to
avoid the possibility of harmful emissions.
Cautions and warnings
CAUTION:
A caution identifies something that might cause you harm.
W
ARNING
:
A warning identifies something that might damage your printer hardware or
software.
Electronic emission notices
Federal Communications Commission (FCC) compliance information
statement
The Lexmark T420 and T420n laser printers, Type 4048-001 and 4048-002, respectively, have been
tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
The FCC Class B limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult your point of purchase or service representative for additional suggestions.
The manufacturer is not responsible for any radio or television interference caused by using other than
recommended cables or by unauthorized changes or modifications to this equipment. Unauthorized
changes or modifications could void the user’s authority to operate this equipment.
Note: To assure compliance with FCC regulations on electromagnetic interference for a
Class B computing device, use a properly shielded and grounded cable such as
Lexmark part number 1329605 for parallel attachment or 12A2405 for USB
attachment. Use of a substitute cable not properly shielded and grounded may
result in a violation of FCC regulations.
Summary of Contents for T420
