59
20
Replacing the fuser assembly
Order a new fuser assembly when toner fog or background shading appears on printed pages. See
Ordering supplies
for information on ordering a fuser assembly.
Complete the following steps to replace the fuser assembly. Refer to the documentation that comes
with the fuser assembly for detailed installation information.
CAUTION:
The fuser assembly is hot! Turn the printer off and wait twenty minutes before
changing the fuser assembly.
1
Turn the printer off, unplug the printer power cord, and wait twenty minutes.
2
Remove the top cover and all installed output options. If a duplex unit is installed, remove it.
3
Remove the fuser cover.
4
Lift up and remove the fuser cleaner.
5
Open the rear access door and remove the redrive.
6
Remove the old fuser assembly.
Note: For best results, use Lexmark supplies with the printer. If you are in the U.S. or
Canada, call 1-800-438-2468 for information about Lexmark Authorized Supplies
Dealers in your area. In other countries, contact the place where you bought your
printer.
7
Install the new fuser assembly and replace the redrive.
8
Close the rear access door and replace the fuser cover.
9
If you have a duplex unit, reinstall it. Reinstall all output options and the printer top cover.
10
Plug the printer power cord into a properly grounded electrical outlet.
11
Reset the maintenance counter
.
Summary of Contents for T620
